User manual

GETTING STARTED 10
UNPACKING THE REPLICATOR+
Open the Box
Open the box containing your MakerBot Replicator+
and remove the setup kit.
Remove Build Platform Clip
Remove the clip that prevents the build platform
from moving during shipping. Save this clip! It will be
handy if you ever need to transport your MakerBot
Replicator+ in the future.
Remove the MakerBot Replicator+
Remove the MakerBot Replicator+ from its plastic bag
and set it down on a stable surface.
Remove Gantry and Extruder Carriage Clips
Remove the two clips on each side of the MakerBot
Replicator+ that hold the gantry and extruder carriage
in place during shipping. Save these clips! They will
be handy if you ever need to transport your MakerBot
Replicator+ in the future.