User Manual

Page 3/7
Material Safety Data Sheet
acc. to ISO/DIS 11014
Printing date 01/07/2013 Reviewed on 01/07/2013
Trade name: ABS Model
(Contd. of page 2)
34.2.6
·
Environmental precautions:
Do not allow to enter sewers/ surface or ground water.
·
Methods and material for containment and cleaning up:
Pick up mechanically.
Allow to solidify. Pick up mechanically.
Dispose of the collected material according to regulations.
·
Reference to other sections
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.
7 Handling and storage
·
Precautions for safe handling
Ensure good ventilation/exhaustion at the workplace.
Prevent formation of dust.
If dust/smoke is developed, avoid breathing dust/smoke.
Avoid contact with eyes.
Avoid long or repeated skin contact.
Avoid contact with hot product.
Make sure that all applicable workplace limits are observed.
·
Information about protection against explosions and fires:
Dust can combine with air to form an explosive mixture.
Keep ignition sources away - Do not smoke.
Protect against electrostatic charges.
·
Storage
·
Requirements to be met by storerooms and receptacles:
Observe all local and national regulations for storage of water polluting products.
·
Information about storage in one common storage facility:
Not required.
·
Further information about storage conditions:
Store in cool, dry conditions in well sealed receptacles.
·
Specific end use(s)
No further relevant information available.
8 Exposure controls/personal protection
·
Additional information about design of technical systems:
No further data; see item 7.
·
Components with limit values that require monitoring at the workplace:
Observe all workplace limits for dust:
TLV inhalable dust: 15 mg/m³ OSHA
TLV respirable dust: 5 mg/m³ OSHA
·
Additional information:
The lists that were valid during the creation were used as basis.
·
Personal protective equipment
·
General protective and hygienic measures
Do not inhale dust / smoke / mist.
Avoid contact with the eyes.
Avoid close or long term contact with the skin.
Avoid skin contact with the liquefied material.
Wash hands before breaks and at the end of work.
·
Breathing equipment:
If all workplace limits are observed and good ventilation is ensured, no special precautions necessary.
·
Protection of hands:
No chemical-protective gloves required.
Use heat resistant gloves when handling hot/molten product.
·
Eye protection:
Safety glasses
·
Body protection:
Protective work clothing.
(Contd. on page 4)
USA
209330-0001 (B)