User's Guide

MakerBot Sketch
Filament check: To turn on/off the filament check, notice will pop out when
filament is used up or suspended when the check is turned on.
Door open check: To turn on/off the door open check, notice will pop out when door is
open when the check is turned on.
Light: To turn on/off the light.
Light: To turn on/off the light.
Shows the basic information about the printer.
Notice: When contacting after-sales support, please give your Serial No to after-sales
engineer, which is showed in the [About] interface.
About:
2
/
2
<
1
/
2
<
Machine
Type:
Serial No:
RegisterCode:
Firmware Version:
123456
WWNKDO
1.0.0 20170909
2
/
2
<
Build
Volume:
Usage counter:
IP Address:
150 x 150 x 150
12 hours
10.90.243.184: 8899
2
/
2
< <
< <
<
26