Use Instructions

Resetting the drone
When the flight of the drone is unstable or deviated from the left and right after take-off, the
consumer can correct the gyroscope and the flight will be more stable after the correction.
1. Turn on the drone & controller, place the drone on
a flat ground (it is very important), then push the left
throttle of the controller up & down once to pair with
the drone.
2. Then push left throttle of the controller to bottom left
and right throttle to the bottom right at the same time
and hold for a few seconds. This will reset the drone
to its defualt settings & will be ready to fly again.
1.Speed modes:
Select between 3 speed modes:
40% speed (controller makes 1 beep);60% speed (controller makes 2 beeps);
100% speed (controller makes 3 beeps)
2.360 Flips:
Perform 360 flips by pressing the “flip” button and immediately push the right stick to the
direction that you want the drone flip.
4.Headless mode:
In order to activate this mode,press the headless button you will hear incontinuous beeps,
the drone will displace according to the direction of the stick command do not matter where
the drone is pointed at. Press the headless button again,to go back to the normal mode.
3.Auto return button:
Press the auto return button, the drone will automatically return in the direction of the tail
before takeoff. (Most of all, consumers must keep in mind the drone orientation before the
drone takes off, otherwise the return direction of the drone will deviate.)
5.Emergency Stop:
Only stop motors mid-flight in an emergency situations,
Doing so can reduce the risk of damage or injury.
Press the button on the controller, the motors will stop spin immediately.
6.One key start/stop:
Press the one key start button, the propellers will rotate. Push up the throttle
left stick to take off.
Press the one key stop button, the drone will land by itself
o
7.LED:
Press the LED button to turn off/on the lights.