ONE ROBOT PER CHILD Shenzhen Maker Works Technology Co., Ltd Technical Support: tec-support@makeblock.cc www.makeblock.
Contents mBot is an educational robot for beginners to learn STEM (Science, Technology, Engineering, Mathematics) and experience the charms of mechanics, electronics, control system and computer science.
Part List WARNING: CHOKING HAZARD - Small parts. Suggested for children over 12 yrs. mCore Casing USB Cable Screw M4x8 RJ25 Electronic Cable Bluetooth/2.4G Module Dual-purpose mCore Screwdriver AA Battery Holder (This kit does not include AA batteries.
mCore Assembly AA Battery Holder Interface 3.7V Lithium Battery Interface Chassis Motor (Right) Nut M3 Screw M3x25 x1 x1 x2 x2 Motor (Left) Nut M3 Screw M3x25 x1 x2 x2 Reset USB Connector Power Switch Motor Interface Self-drilling Screw M2.
Screw M4x8 x2 Screw M4x8 x2 mCore Casing x1 Mini Auxiliary Wheel x1 Me Ultrasonic Sensor x1 mCore x1 Line Follower Sensor x1 Bluetooth/2.4G Module x1 Note: Please check carefully if the pins of the Bluetooth or 2.4G Module Ma ke blo ck are well installed, otherwise the chip may be damaged upon After assembly, make sure to take out all the wires through here. 5 6 8 7 9 Brass Stud M4x25 x4 10 power-on.
3.7V Lithium Battery Casing Screw M4x8 x4 x1 Note: If you use AA battery holder, please skip step 13, 14, 15, and 16. 3.7V Lithium Battery x1 AA Bettery Holder Velcro x1 x1 13 14 17 18 16 20 19 15 Screw M4x8 x4 Ma ke blo ck Ma ke blo ck Ma ke blo ck Please wire the electronic modules after assembly.
Batteries Suggestion Wiring Note: You may need to switch the sequence AA Battery Holder mCore Voltage Range: 3.7V DC-6V DC. There are two options for the power supply: of two wires (M1, M2) to correct rotation direction. Bluetooth/2.4G Module Option 1: 4 x AA batteries (Not included) Option 2: 3.7V Lithium Battery (not included) with standard 2.0 interface. It supports on-board charge via USB Me Ultrasonic Sensor cable. Ma ke blo ck 3.
Factory Setting Graphical Programming Now it’ s time to test your mBot after it’ s fully assembled. 1. Introduction to mBlock mBot has three pre-set modes: IR control mode, obstacle avoidance mode and line-following mode. for the hardware interactions, which can help you read the sensor's value, mBlock is a graphic programming software developed based on Scratch 2.0 control the output of hardware modules and program the robot in a quick way.
Wireless Communication 1. Introduction to Bluetooth Module Arduino Programming (C Language) 2. Introduction to 2.4G Module The Bluetooth module is designed specially for mCore with the The 2.4G module is includes two parts: 2.4G wireless serial-USB support of Bluetooth 2.0 and 4.0. It is suitable for both individual for computers, 2.4G wireless serial-module for mCore. It uses users and family.
Electronic Modules on Makeblock--Further Exploration Z Me 3-Axis Accelerometer Me Sound Sensor can measure the volume. It and Gyro Sensor can measure the moving location of the objects, can be used in some sound interactive projects, such as an e.g., detecting bumps for sumo robots. voice operated switch. X Y http://learn.makeblock.
