User manual

Electrocution hazard!

Always turn the Eurorack case o and unplug the power cord before plugging or unplugging any Eurorack

bus board connection cable.

Do not touch any electrical terminals when attaching any Eurorack bus board cable.

The Make Noise MATHS is an electronic music module requiring 60mA of +12VDC and 50 mA of -12VDC

regulated voltages and a properly formatted distribution receptacle to operate. It must be properly installed

into a Eurorack format modular synthesizer system case.

Go to http://www.makenoisemusic.com/ for examples of Eurorack Systems and Cases.

Please refer to your case manufacturers’ specications for location of the negative

supply.

-12V

To install, 20HP in your Eurorack synthesizer case, conrm proper installation of included Eurorack Busboard

connector cable on backside of module (see picture below), plug the bus board connector cable into the

Eurorack style bus board, minding the polarity so that the RED stripe on the cable is oriented to the

NEGATIVE 12 Volt line on both the module and the bus board. On the Make Noise 6U or 3U Busboard, the

negative 12 Volt line is indicated by the white stripe.