User manual

PATCH NOTATIONS :
In this manual, patch instructions will be notated like this (the represents a patch cable connected to the two jacks):
For example:
As you may have guessed, this is instructing you to patch the Square Wave Output ftom the 0-Coast’s Oscillator Circuit to the
External Input of the Balance Circuit. Don’t worry if it sounds daunting, you’ll quickly get the hang of it. Accompanying the
written patch instructions, you’ll also nd small, visual representations of the connections. Continuing the example above:
SCOPE NOTATIONS :
Circuit
Output
Circuit
Input
Oscillator
Square Wave Output
Balance
External Input
Number of Cycles
1 Second
=
Frequency in Hz
+5V
Figure 2:
Anatomy of a Signal Diagram
-5V
Time, Seconds or Milliseconds
1 Period or Cycle
0V
Amplitude, Volts
In this manual, patch examples are sometimes shown with an illustration that
resembles the signal(s) as displayed on an oscilloscope. These drawings are
for diagrammatic and/or conceptional purposes only and not intended
for laboratory use. Scope diagrams are not to scale.
55
Sample Figure: