Instruction Manual

8
4. Data memory and Data transmitting
Ÿ If you want to start recording, the corresponding sensor must connect
to the data logger or you can not start it. In the process of
measurement if the sensor is disconnected because of some reason it
will stop recording.
Ÿ When the memory is full, the Data Logger will stop recording and turn
off, when downloading data to PC you need to turn on the Data Logger.
The data can be read time after time until a new setup is done.
Ÿ After a new setup from PC software, all of the data in Data Logger will
be deleted, and the max and min value is set to 0.
5. Caution before connecting
Ÿ Before recording data, please make sure the sensors have been
connected (Voltage sensor or current sensor)
Ÿ Please make sure the wires are securely attached to the connector and
that no uninsulated portion of the wire is visible after the connection is
made.
Ÿ The connection wire of the sensor and Data Logger must not be too
taut to prevent pulling out while recording.
6. Software Introduction
6.1. Installation
System Required:
Windows 10 and above.
Software Introduction:
1. Insert the USB into a vacant slot. Open the location containing the
installation files.
2. After the software is installed, keep the USB in the PC and connect the
data logger with the PC by the USB cable. Then, there will be a USB
Driver installation window pop-up. Follow the icons, select the path of
USB driver and Windows will automatically install the driver from that
location.