Rev. 5/16, Ver.
TABLE OF CONTENTS ASSEMBLY TIPS & WARNINGS 3 PARTS IDENTIFIER 4 5-10 ASSEMBLY INSTRUCTIONS OPERATION INSTRUCTIONS 11 ENJOYING YOUR SAUNA 12 HEALTH & SAFETY WARNINGS 13 CLEANING & MAINTANENCE 14 TROUBLESHOOTING GUIDE 14-15 REPLACEMENT PARTS 16-19 WARRANTY INFORMATION 20 If you would like a French version of this manual, please contact our Customer Service Department at 800-759-0977 or custserv@splashnetxpress.
ASSEMBLY TIPS & WARNINGS • Before you begin, read all assembly instructions and safety warnings carefully. • This sauna requires at least 2 adults to complete assembly. • Remove all of the contents from boxes and verify that you have all of the parts shown on the Parts Note: Some parts may be pre-installed or pre-assembled. may not look exactly like your product. • Retain this Owner’s Manual for future reference.
PARTS IDENTIFIER (NOT TO SCALE) This manual is used for the assembly of several sauna models; therefore, some images or drawings may not look exactly like your product. * Refer to REPLACEMENT PARTS (PAGE 16-19) to determine the correct part number when ordering replacements. For replacement parts please call 800-759-0977.
ASSEMBLY INSTRUCTIONS 1. Begin assembly by determining an appropriate location for your sauna – see ASSEMBLY TIPS & WARNINGS for details. Attach the BACK PANEL to the FLOOR by lining up the BACK PANEL with the groove in the back of the FLOOR. 2. Attach the LEFT PANEL to the FLOOR. Buckle the LEFT PANEL to the BACK PANEL. 3. Attach the RIGHT PANEL to the FLOOR. Buckle the RIGHT PANEL to the BACK PANEL.
ASSEMBLY INSTRUCTIONS (CONT.) 4. Carbon Heater Models Only: Attach the FLOOR HEATER to the FLOOR with 1-1/2” SCREWS. Connect the heater plug. 5. Slide the BENCH HEATER PANEL into place between the LEFT and RIGHT PANELS. Connect the heater plug. Note: For Carbon Heater Models, make sure the FLOOR HEATER cable is placed through the groove in the bottom of the BENCH HEATER PANEL. 6. Attach BENCH SEAT with 2” SCREWS.
ASSEMBLY INSTRUCTIONS (CONT.) 7. Ceramic Heater Models Only: Attach BACK PANEL HEATER COVER to BACK PANEL with 2” SCREWS and to BENCH SEAT with 3/4” SCREWS. 8. Attach the FRONT PANEL to the FLOOR. Buckle the FRONT PANEL to the LEFT and RIGHT PANELS. 9. Lift the ROOF above the sauna, feeding the control panel and heater cables through the corresponding holes. Feed the cables for the AM/FM CD PLAYER through the hole in the bottom of the ROOF. Secure the ROOF to the sauna with 1-1/8” SCREWS.
ASSEMBLY INSTRUCTIONS (CONT.) 10. Feed the main power cable through hole in ROOF and plug securely into receptacle on back of POWER SUPPLY box . Secure the ROOF COVER with 3/4” SCREWS. 11. Attach the DOOR HANDLE to the GLASS DOOR by assembling parts (A) as shown (for top and bottom of handle), then inserting set screws (B) into handle and screwing into fitting (C). B A C GLASS DOOR INSIDE OUTSIDE 12. Gently pull the cables for the AM/FM CD PLAYER through the opening in the front of the STEREO SHELF.
ASSEMBLY INSTRUCTIONS (CONT.) 13. Plug the controller and antenna into the back of the AM/FM CD PLAYER. Slide and lock the AM/FM CD PLAYER into the STEREO SHELF. 14. Attach the MAGAZINE RACK with 1-1/2” SCREWS. Note: A sticker indicates the optimal position for this accessory, but attaching it is optional. Consider the position carefully before driving any screws into the sauna interior. 15. Attach the CUP HOLDER(S) with 3/4” SCREWS.
ASSEMBLY INSTRUCTIONS (CONT.) 17. Two-Person Models Only: Remove the back cover of the OXYGEN IONIZER by turning is as indicated. Unwrap and install the fragrance patch, then reattach the back cover. Attach the OXYGEN IONIZER in the designated position with 3/4” SCREWS. Plug the power cable into the OXYGEN IONIZER. 18. Plug the main power cable into a dedicated outlet. Note: No other appliances should share the same outlet with this sauna. CONGRATULATIONS! The assembly of your sauna is now complete.
DIGITAL CONTROL OPERATION INSTRUCTIONS 1. Press POWER to turn ON the sauna. Left window displays temperature, the right one displays time. 6 2. Set the desired TEMPERATURE with the (+) and (-) buttons. 3. Press and hold both (+) and (-) to switch between °F (Fahrenheit) and °C (Celsius). 4 4. Set the desired TIME with the (+) and (-) buttons. 2,3 5. Press INSIDE or OUTSIDE to turn on or off the corresponding light. 8 6. When the TIME reaches 00, the heaters will turn OFF automatically.
ENJOYING YOUR SAUNA 1. Prior to initial use, wipe down all interior surfaces of the sauna with a damp cloth. 3. Always drink plenty of water before, during and after your sauna session to stay properly hydrated. 4. A normal sauna session should last 30 minutes or less. 5. Allow approximately 25 to 45 minutes for the sauna to warm up before entering. 6. Perspiration will begin within 10 to 20 minutes after entering the sauna. 7. Limit the use of lotions or oils on your body while using your sauna.
HEALTH & SAFETY WARNINGS 1. Review all instructions and warnings before operating your sauna. A sauna is not a toy. Serious injury may result from negligence, intentional misuse and failure to follow safety instructions. 2. Hyperthermia Danger: Hyperthermia occurs when the body absorbs more heat than it can emergency and requires immediate treatment to prevent disability or death. It is very important not to allow your body’s core temperature to rise above 103° F.
CLEANING & MAINTENANCE 1. Always unplug the sauna and allow it to cool down before performing any cleaning or maintenance. 2. Use furniture polish or furniture oil when cleaning the sauna exterior. 3. The sauna interior surfaces should only be wiped down with a damp cloth. Do NOT use 4. As with all natural wood products, variations in the color and the grain as well as irregunatural beauty of the wood and should not be considered defective.
TROUBLESHOOTING GUIDE (CONT.) Problem Solution Problem THE CONTROL PANEL DOES NOT WORK 1. Check that all the connections are tight. 2. If the numbers are scrambled or the buttons are unresponsive, replace the Control Panel. 3. If the temperature indicator does not work or reads “--” or “EP”, check all connections, then replace the Control Panel if needed. 4. If the temperature indicator reads "H" and the buzzer sounds, this is the built in “high temperature protection”.
REPLACEMENT PARTS Rev. 5/1 16 SA3202 ONE-PERSON HEMLOCK MAJESTIC SAUNA WITH CARBON HEATERS REF.
SA3202 17
REPLACEMENT PARTS Rev. 5/16 SA3209 TWO-PERSON HEMLOCK MAJESTIC SAUNA WITH CARBON HEATERS REF.
SA3209 19
SAUNA WARRANTY REGISTRATION CARD 1. This sauna has a 7-Year Limited Warranty against defects in materials and workmanship from date of purchase. To receive the warranty, the card below must be filled out completely and returned within thirty (30) days from date of purchase. This 7-Year Limited Warranty covers the wood structure*. Heating elements and all electronics are covered by a 5-Year Limited Warranty. The radio/CD player (if included with your sauna) is covered by a limited 1-Year Warranty.
