User Manual

27D7300
50
VWF Series Vented Gas Log Set
REMOTE CONTROL RECEIVER REPLACEMENT
The remote control receiver and batteries are very sensitive to heat. Exposure to high temperatures
can cause the receiver to malfunction and shorten the life of the batteries. If your fireplace does
NOT have a restrictive barrier (Page 6), such as glass doors, it is recommended that the remote
receiver be affixed to the right hand side of the heat shield or placed in the front, right corner of the
fireplace. If your fireplace has a restrictive barrier, it is recommended that the remote receiver be
placed outside of the fireplace.

The log set should be cleaned at least once a year for maximum performance.
Turn gas supply off. Allow unit to cool. Remove logs, handling carefully by holding gently at each
end. Gloves are recommended when handling the log to prevent skin irritation from ceramic fibers.
If skin becomes irritated, wash gently with soap and water. Refer to manual for correct log place-
ment. Brush each log gently with a soft bristle brush. This will remove soot that has built up on the
log set. DO NOT USE LIQUID SOOT REMOVER ON LOGS!
To refurbish the grate, remove grate and take it outside. Use a wire brush or sandpaper to remove
any discoloration to the grate. Paint grate with high temperature black paint (barbecue paint). Rein-
stall grate after paint dries.
If embers (rock wool) have turned a rust color and become brittle, remove old embers (rock wool)
from log set. Replace with new rock wool. Rock wool can be purchased from you local dealer. See
log placement section for placement of embers.
CLEANING AND SERVICING
WARNING
Turn off gas logs and allow to cool before
cleaning. Disconnect electrical power if
applicable before cleaning or servicing.
LG911
clean log