User Manual
27D7300
14
VWF Series Vented Gas Log Set
LOG PLACEMENT
FILLING THE BURNER PAN
Fill the burner pan with vermiculite to the bottom of the rear log and sloped to the front edge of the
burner pan. Excess vermiculite can spill forward or to the side of the burner pan. Do not overll the
propane model. Do not cover the pilot (if SPK or MVVK is installed) with vermiculite or rock wool
(embers).
PLACEMENT OF GLOWING EMBERS (ROCK WOOL)
The Wildre ame appearance can vary due to differences in draft and replace congurations and
ember placement. After installing rear (#1) and front logs (#2 and #3), cover the entire top surface
of the vermiculite in the burner pan with the rock wool supplied with unit. Tear the rock wool into
pieces approximately 1/2" in size (roughly the size of a nickel) and cover the burner evenly. Do
no use more rock wool than the amount supplied with the unit. To enhance the appearance of the
Wildre ame, it is recommended to form a mound of rock wool in the center of the burner, 2" to 3"
high, visible through the two front logs.
PLACEMENT OF DECORATIVE VOLCANIC ROCK
Sprinkle volcanic rock in front of front glowing embers and to both sides.
DO NOT SPRINKLE ON BURNERS, EMBER BED, PILOT OR LOGS.
VWF18 MASSIVE OAK LOGS
1. Slide shield plate behind burner pan. Figure 17.
2. Center rear log #1 on grate bars and ush with rear of
the grate. Figure 18.
LG837
VWF18 shield plate
Shield Plate
Burner Pan
LG837
LG838
VWF18MO rear log
Rear Log #1
LG838