User Manual
32D1999
"Duzy" Series Vented Gas Log Sets
24
1. Read the safety information label.
2. Make sure the manual shutoff valve is fully open.
3. This gas log set is equipped with an ignition device (piezo) which automatically lights the pilot. If piezo
ignitor does not light the pilot, see instructions for “Match Lighting Instructions,” Page 25.
4. Push in gas control knob slightly and turn clockwise to “OFF.”
NOTE: Knob cannot be turned to “OFF” unless knob is pushed in slightly.
5. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the
floor. If you smell gas, Follow “B” in the safety information label. If you don’t
smell gas, go to next step.
6. Find pilot - follow metal tube from gas control.
7. From “OFF” position, push in gas control knob slightly and turn counterclockwise
to “PILOT.” Push in control knob for 5 seconds.
8. With the control knob pushed in, immediately light the pilot by depressing the piezo
and releasing. Continue to hold the control knob in for about one (1) minute after
the pilot is lit. Release knob and it will pop back up. Pilot should remain lit. If it
goes out, repeat steps 5 through 9.
• If knob does not pop up when released, stop and immediately call your service
technician or gas supplier.
• If the pilot will not stay lit after several tries, turn the gas control knob to off
and call you service technician or gas supplier.
9. Turn gas control knob counterclockwise to “ON.”
1. Push in gas control knob slightly and turn clockwise to "OFF". Do not force.
This appliance is equipped with an ignition device which automatically lights the pilot.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle on the floor.
• Do not attempt to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will not push
in or turn by hand, don't try to repair it. Call a qualified service technician. Force or attempted repair
may result in a fire or explosion.
Do not use this appliance if any part of it has been under water. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the control system and any gas control
that has been under water.
WARNING
FP2849
manual pilot flame
FP2860
pilot knob