User Manual
32D1999
"Duzy" Series Vented Gas Log Sets
22
Cover the burner pan with glowing embers (rock wool)
provided. Tear pieces approximately 1/2" in size (roughly
the size of a nickel) and cover the burner evenly.
1. Pile the rock wool too thickly on pan.
2. Place rock wool higher than the top of the front grate
bar.
3. Cover the pilot with rock wool.
Sprinkle volcanic rock in front of front glowing embers
and to both sides.
It is critical to verify that your chimney is drafting
properly because the fireplace and gas logs function
as a system.
Although MHSC goes to great lengths to design
vented gas log sets that minimize sooting, all vented
log sets will soot over time. Sooting normally appears
as areas of a black powder-like substance on the
logs. It is important to periodically clean and inspect
the logs per the cleaning and servicing section of the
manual.
To determine if your fireplace is drafting properly, turn the
log set on. After the log set has been burning for about 10
minutes, place a match or smoke stick along the top and
sides of the fireplace opening. If the flame or smoke is not
pulled into the fireplace, then the
At this point the damper stop should be adjusted
so that the damper opening is increased. If the problem re-
mains after the open area of the damper is increased, then
the fireplace system should be professionally inspected to
determine if your firebox/chimney is venting properly.
WARNING