Installation Instructions
43
Majestic • RUBY25IN, RUBY25IL, RUBY30IN, RUBY30IL, RUBY35IN, RUBY35IL Installation Manual • 2542-980 Rev. i • 9/19
Figure 1. Log Identication
Figure 4. Log #2 Installed
Figure 3. Log #1 Installed
Figure 2. Burner Location
MODELS: RUBY35IN, RUBY35IL
LOG #3: Place the big end of Log #3 against log pin F and the burnout end on the at spot of Log #1. The front point of Log
#3 should line up with the edge of the base refractory. See Figure 5.
Figure 5. Log #3 Installed
1
2
3
4
5
6
7
8
9
RUBY35 SRV LOGS
LOG ID SRV PART # MOLDED LOG #
1 SRV2544-711 44-1
2 SRV2544-715 44-5
3 SRV2544-712 44-2
4 SRV2544-716 44-6
5 SRV2542-717 44-7
6 SRV2542-717 44-7
7 SRV2542-717 44-7
8 SRV2540-713 44-3
9 SRV2540-713 44-3
Mystic Embers: The RUBY come standard with Mystic Embers. Refer to the appliance installation manual for instructions on
how to properly install the Mystic Embers in the appliance. The Mystic Embers must be installed after the logs are installed.
LOG #1: Place the pilot hood cutout of Log #1 over the pilot hood and slide it back until it sits ush against the air scoop.
See Figure 3.
Note: Logs #5, #6 and #7 are the same log and logs #8 and #9 are the same log.
LOG #2: With the split side of Log #2 facing right, place the center of the small end of the log against log pin A. The big end
of Log #2 will sit on the at spot of Log #1. See Figure 4.
A
B
C
D
E
F
G
PILOT HOOD
AIR SCOOP
1
1
2
A
1
3
F