User Manual
9
PH Gas Logs
65D2035
FP2923
heat resist matl w mantel
Hood
Heater in
Fireplace or
Figrebox
8" or More of Heat
Resistant Material
FP2923
Figure 5 -
Measure Heat Resistant Material for Mantel
To install the heater with a wooden mantel, shelf or other
combustible projection above, rst measure the heat resis-
tant material shown in Figure 6, then see TABLE B.
12" or more Hood not required. Observe proles
(side elevations) shown in Figure 7
8" or less than 12" Install hood (CABR/CABL) and
observe proles show in Figure 6;
extend heat resistant material to
at least 12" and observe proles
shown in Figure 7
Less than 8" Extend heat resistant material
to at least 8" and install hood (CABR/
CABL) and observe proles shown in
Figure 6; extend heat resistant
material to at least 12" and observe
proles shown in Figure 7.
Table B -
Heat Resistant Material Heights and Mantel Location
FP2534
Min. mantel w hood
10"
8"
6"
256O"
8" 1456O" 186" 2256O" 26"
12"
Heat
Resistant
Material
Hood
Heater in
Fireplace or
Firebox
FP2534
12”
Min.
28”
10” or Less
FP2535
min mantel no hood
Heat
Resistant
Material
Heater in
Fireplace or
Firebox
FP2535
Figure 7 -
Minimum Mantel Clearance with No Hood
Figure 6 -
Minimum Mantel Clearance with Hood
Example: The bottom of the mantel may project from the
wall a of 10" at a of 28"
above the opening.
Example: A mantel may project from the wall a
of 2Z\x" at a of 8" above the opening
and a of 6" at a of 14Z\x"
above the opening.