Decorative Shroud Install Manual

Hearth & Home Technologies Inc. • LDS33/LDS46 Decorative Shrouds • 31173 • Rev E • 04/09
8
2
2
LDS33/LDS46 Installation Around Direct Vent Gas Termination Caps
• The LDS33/LDS46 Decorative Shroud may also be used with the DVP-TV, DVP-TVHW or SLP-TVHW direct vent vertical
termination caps (Figures 24-26).
• Minimum dimensions for the shroud are shown in Figure 27.
• After you have met or exceeded the minimum dimensional requirements, continue with Section 1.B.
7-1/4 in.
(184 mm)
5-1/4 in.
(133 mm)
12-1/2 in.
(318 mm)
10-1/2 in.
(267 mm)
3-7/8 in.
(98 mm)
Figure 24 DVP-TV Direct Vent Vertical Termination Cap
Figure 25 DVP-TVHW Direct Vent Vertical Termination Cap
7-1/4 in.
(184 mm)
5-1/4 in.
(133 mm)
12-1/2 in.
(318 mm)
Figure 26 SLP-TVHW Direct Vent Vertical Termination Cap
16 in. (406 mm)
Minimum
Field
Constructed
Shroud
Maximum Height of
14 1/2 in. (368 mm)
Open
Top
Only
19 in. (483 mm)
Minimum
Roof
Chase
3 in. (76 mm) air
space from bottom
of shroud to top of
chase
Figure 27 Minimum Dimensions of Shroud & Chase