Specification Sheet

Specifications
PRODUCT LISTING CODES
US ANSI Z21.88-2017
CAN CSA 2.33-2017
UL307B
Product information provided is not
complete and is subject to change
without notice. Product installation
must adhere strictly to instructions
accompanying product to avoid risk
of fire and potential injury.
ECHEL48ST
MINIMUM FIREPLACE CLEARANCES
FRAMING DIMENSION
CLEARANCES TO COMBUSTIBLES
MANTEL PROJECTIONS - NON-COMBUSTIBLE
MANTEL PROJECTIONS - COMBUSTIBLE
Note: All measurements in inches.
MEASUREMENTS FROM TOP EDGE
OF THE APPLIANCE OPENING
4
5
6
13-16
3
2
1
6
7
8
9
10
11
18
31
MAX.
MIN.
TO CEILING
Measurement from top edge of opening
to bottom of appliance = 24-1/2"
OVERLAP FIT
MEASUREMENTS FROM TOP EDGE
OF THE APPLIANCE OPENING
4
5
6
14-16
9
10
18
31 MIN.
MAX.
TO CEILING
Measurement from top edge of opening
to bottom of appliance = 24 -1/2"
7
11
INSIDE FIT
Note: All measurements in inches.
MEASUREMENT FROM
TOP EDGE OPENING
18
20
23
26
29
31
TO CEILING
9
12
6
3
1
Measurement from top edge opening
to bottom of appliance = 24-1/2"
MAX.
Note:
All measurements in inches.
APPLIANCE LOCATION
1/2" [13]
1/2" [13]
17-1/8" [435]
48" [1219]
60-1/4" [1530]**
48" [1219]
NOTICE:
This see-through appliance is NOT designed
or approved for an indoor/outdoor application.
If Passive Heat, HEAT-ZONE
®
or HEAT-OUT will be installed,
refer to section 6 of the installation manual for instructions.
MANTEL LEG/WALL PROJECTIONS
COMBUSTIBLE OR NON-COMBUSTIBLE
WALL PENETRATION
3' maximum
4-1/2"
minimum
FIREPLACE OPENING
See appliance dimension diagram
in install manual - Dimension B
Note: Clearance from
opening to
perpendicualar wall
Top View
FIREPLACE OPENING
See appliance dimension diagram
in install manual - Dimension B
Note: Clearance from
opening to
perpendicualar wall
Top View
7"
minimum
UNLIMITED
Acceptable on both sides of opening
75"
[1905]
10"
12"
74"
[1880]
Do not pack with insulation or
other material.
* Shows center of vent framing
hole for top venting. Center of hole
is 1" [25] above center of horizontal
vent pipe.
31"
[787]
0" [0]
0" [0]
1" [25]
48" [1219]
55-1/2"
[1410]
Header depth
not to exceed
3-1/2" [89]
Header
depth
not to
exceed
3-1/2" [89]
Adjust framing dimensions
for interior sheathing (such
as Sheetrock).
If appliance is installed o of oor,
maintain required clearances to
combustibles. Construct platform in
accordance with local building codes.
10" [254]
42"
[1067]
17" [432]
60-1/4"
[1530]
GS/MAJ/ECHEL48ST_0819
Majestic — A Brand of Hearth & Home Technologies
7571 215th Street West | Lakeville, MN 55044
877-486-9123 | majesticproducts.com