Manualshelf

Installation Sheet

ManualsBrandsMajestic ManualsFireplaces and FirepitsMajestic 40000 BTU 48 Inch Wide See-Through Direct Vent Natural Gas Fireplace with IntelliFire Plus Ignition and Remote Control
69707172737475767778
71
Majestic • ECHEL36IN-C/STIN-C, ECHEL48IN-C/STIN-C, ECHEL60IN-C, ECHEL72IN-C Installation Manual • 2608-980 Rev. C • 8/19
G. IntelliFire™ Touch Control System Setup
• Detailed instructions for electrical wiring and
connections are provided in Section 8.
• Determine if this appliance is equipped with a Module
Reset Switch. See Section 8. Verify this switch is in
the ON position.
• Verify that the 3-Position switch on the IFT-ECM is
switched to the REMOTE position. Detailed Operating
Instructions for the IFT-ECM are provided in Section
3.K of the Owner’s Manual.
Figure 11.4 IFT-ECM
This appliance is factory-equipped with an IntelliFire™
Touch
remote control. The remote was paired to the
replace and tested at the factory. It does not need to
be paired again, unless an accessory kit will be added
at the time of installation. If no additional accessory will
be added, simply follow steps one through seven below.
1. If installed, remove batteries from remote.
2. Verify that the new appliance has power and secure
electrical connections.
3. Adjust the ECM selector switch to ‘REMOTE’ mode.
4. Switch the master reset switch to ‘ON’ (if equipped).
5. Wait to verify LED indicator on the ECM stops ashing.
6. Install batteries in the RC400 remote.
7. The RC400 remote will automatically pair to the
appliance as pre-set at the factory.
3 POSITION SWITCH
TOP VIEW
LED INDICATOR
Figure 8. Install Bottom Glass Shield
TROUBLESHOOTING
After the initial start up burn, it may be necessary to
adjust the media placement to achieve the best ame
appearance. While ame height variation is normal, there
may appear to be higher peaks in some areas and low
ame peaks in other areas.
If the ame height appears to be excessively high in
some spots, applying more media to these areas on top
of the burner will help even out the ames. Spreading
the media as evenly as possible is the most effective way
to achieve optimal ame appearance and the most even
ame heights. One or more test burns may be required
to watch the ames mature and see how even they look
before making adjustments.