Installation Sheet

Majestic • ECHEL36IN-C/STIN-C, ECHEL48IN-C/STIN-C, ECHEL60IN-C, ECHEL72IN-C Installation Manual • 2608-980 Rev. C • 8/1970
Figure 6. Media Installed
NO MEDIA ALLOWED
NO MEDIA IN GLASS RAIL
Figure 7. Media Placement Restriction Area
ECHEL60IN-C AND
ECHEL72IN-C MODELS
ONLY
DO NOT PLACE MEDIA IN THIS AREA
9. ECHEL60IN-C and ECHEL72IN-C ONLY:
DO NOT place media in front of opening on right side
of the burner (60 and 72 only). Flame appearance will
be affected. See Figure 7.
10. Check between the pilot and burner and remove any
media that has fallen into this area.
11. Turn the appliance on to verify that the pilot and the
burner light properly.
12. Remove any glass media that may have fallen in the
bottom glass rail. Glass will not install properly if media
is present in glass rail. See Figure 6.
13. Reinstall glass assembly.
14. Install bottom glass shield between glass and glass
frame. See Figure 8.
15. Reinstall mesh front.
6. Place the media set aside in Step 1 over the pilot
shield and areas shown in Figure 4 uncovered by
removing the media placement jig. See Figure 4. DO
NOT allow any media in the 1 inch area shown in
Figure 5.
7. Check the pilot area to ensure there is no media
in between the end of the burner and the pilot.
Performance issues will occur if media is present.
WARNING! Risk of Explosion! DO NOT place media
between end of burner and pilot. Delayed ignition could
occur.
Figure 4. Media Installed with Media Placement Jig Removed
Figure 5. Pilot Shield Media installation.
MEDIA ALLOWED
ON PILOT SHIELD
NO MEDIA
ALLOWED
APPROX. 1 IN.
SQUARE
8. DO NOT allow media to fall between the media tray
and the back of the rebox. Remove any fallen media
before proceeding. See Figure 6.