Installation Sheet

Majestic • ECHEL36IN-C/STIN-C, ECHEL48IN-C/STIN-C, ECHEL60IN-C, ECHEL72IN-C Installation Manual • 2608-980 Rev. C • 8/1960
Non-Combustible Finish Materials
NOTICE: This four inch maximum not only includes the
decorative nish materials (marble, tile, slate, etc) but also
the thin set, lath and adhesive used to attach the decorative
nish material.
Note: When a Clean Face Trim decorative barrier front
is installed, the rectangular holes in bottom access panel
will be covered.
Clean Face Trim Front (CFT)
Inside Fit (1-4 Inches Thick Finishing Method)
There are two options for this method of nishing:
With Decorative Trim Ring: (Option #2)
The trim ring, which is included with the CFT front, will be
installed and used as a nishing template. It will be left
exposed.
WARNING! Risk of Fire! DO NOT apply nishing mate-
rial beyond the trim ring. Appliance will overheat if nish-
ing material extends into appliance opening.
1. Remove bottom nishing template from bottom access
panel. Verify that factory-installed nishing guards are
installed to ensure nishing material does not extend
into the replace opening. See Figures 10.2 and 10.3.
2. The non-combustible nish material, 1-4 inches thick,
should be installed up to the replace opening on all
four sides, including the bottom access panel, cover-
ing the eight rectangular holes. Refer to Figure 10.4.
WARNING! Risk of Fire! DO NOT apply nishing mate-
rial beyond the nishing guard. Appliance will overheat if
nishing material extends into appliance opening.
NOTICE: Decorative barrier front will not t properly if
nishing material is applied beyond the nishing guard.
3. Follow Inside Fit section of the instructions provided
with decorative barrier front.
1. Remove nishing template from bottom access panel.
2. Remove top and bottom nishing guards.
3. Install trim ring (included with CFT decorative barrier
front). Push trim ring completely into the opening.
4. Place trim ring into position and install the four shoul-
der bolts through the trim ring as shown in Figure 10.6.
Install the screw as shown in Figure 10.5.
Finishing materials may be installed up to the trim ring but
must not extend beyond it. See Figure 10.7.
Figure 10.5 Install Trim Ring
Figure 10.6 Install Shoulder Bolts
BOTTOM GLASS SHIELD
SHOULDER
BOLTS (4)
RECTANGULAR HOLE
BOTTOM PANEL
BOTTOM FINISHING TEMPLATE
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specied in
this manual. Overlapping materials could ignite.
NOTICE: It is recommended that high temperature silicone
sealant (500º F minimum continuous exposure rating) be
used to adhere the trim ring to the nishing material.
Without Decorative Trim Ring: (Option #1)
Note: You will not use the trim ring, which is shipped with
the CFT front, for this application.
CFT Finishing Method Trim Ring
Inside Fit
Included & Not Used
(Option #1)
Included & Used
(Option #2)