Installation Sheet

59
Majestic • ECHEL36IN-C/STIN-C, ECHEL48IN-C/STIN-C, ECHEL60IN-C, ECHEL72IN-C Installation Manual • 2608-980 Rev. C • 8/19
NOTICE: This one inch maximum not only includes the
decorative nish materials (marble, tile, slate, etc) but also
the thin set, lath and adhesive used to attach the decorative
nish material.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specied in
this manual. Overlapping materials could ignite.
Clean Face Trim Front (CFT)
Overlap Fit (0-1 Inch Thick Finishing Method)
Non-Combustible Finish Materials
1. Remove bottom nishing template from bottom access
panel. Verify that factory-installed nishing guards are
installed to ensure nishing material does not extend
into the replace opening. See Figure 10.2 and 10.3.
2. The non-combustible nish material, 0-1 inch thick,
should be installed up to the replace opening on all
four sides, including the bottom access panel, cover-
ing the eight rectangular holes. Refer to Figure 10.4
for minimum nished opening dimensions.
WARNING! Risk of Fire! DO NOT apply nishing mate-
rial beyond the nishing guard. Appliance will overheat if
nishing material extends into appliance opening.
NOTICE: Decorative barrier front will not t properly if
nishing material is applied beyond the nishing guard.
4. Follow Overlap Fit section of the instructions provided
with decorative barrier front.
FIREPLACE VIEWING AREA
15-3/4 IN.
51-1/8 IN.ECHEL48IN-C/ECHEL48STIN-C
39-1/8 IN.ECHEL36IN-C/ECHEL36STIN-C
63-1/8 IN.ECHEL60IN-C
75-1/8 IN.ECHEL72IN-C
Figure 10.4 Minimum Finished Opening Dimensions - Clean Face Trim Front Method
Note: When a Clean Face Trim decorative barrier front
is installed, the rectangular holes in bottom access panel
will be covered.
B. Decorative Barrier Fronts
WARNING! Risk of Burns! A decorative barrier front is
required for this model. DO NOT operate this appliance
without a decorative barrier front in place.
Note: See appliance Owner’s Manual for TV mounting
guidelines.
Only decorative barrier fronts certied for use with this ap-
pliance model may be used. Contact your dealer for a list
of decorative barrier fronts that may be used.
The decorative barrier fronts approved for use with this
appliance have been designed to be installed by two
methods: Overlap Fit or Inside Fit. Before beginning the
installation, it is important to determine which method will
be used.
Decorative Barrier
Front
Finishing Method Material Thickness Trim Ring
Clean Face Trim (CFT) Overlap Fit 0-1 inch Included & Used