Installation Sheet

Majestic • ECHEL36IN-C/STIN-C, ECHEL48IN-C/STIN-C, ECHEL60IN-C, ECHEL72IN-C Installation Manual • 2608-980 Rev. C • 8/1938
C. Securing and Leveling the Appliance
The diagram shows how to properly position and secure
the appliance. See Figure 6.8. Nailing tabs are provided
to secure the appliance to the framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs ush with the framing.
• Level the appliance from side to side and front to back.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs. Use a minimum of one
fastener per nailing tab.
• Optional: Secure the appliance to the oor by inserting
two screws through the pilot holes at the bottom of the
appliance.
Some gures in manual show the replace installed on the
oor. However, this replace can be elevated off the oor
provided that the replace is properly supported by framing
materials and the ceiling clearances are maintained.
Risk of Fire!
Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible
materials
WARNING
DO NOT remove standoffs or notch the framing
around the appliance standoffs.
Failure to maintain air space clearance could
cause overheating and re.
Block openings into the chase to prevent entry
of blown-in insulation. Make sure insulation and
other materials are secured.
Setting the Fireplace into the Framing
The left and right nailing tabs were designed as a means
to ensure the replace is mounted ush with the framing
materials. See Figures 6.6-6.8.
1. The shipping anges protrude further out from the ap-
pliance than the side standoffs. The shipping ange
may be bent upward or broken off in order to place the
appliance into position in the framing.
2. Bend out all nailing tabs. The see-through model will
have eight nailing tabs. The single-sided model will
have four nailing tabs.
3. Screw each nailing tab to the adjoining framing
material. Ensure that the one inch air space clearance
is maintained on the sides and back of the replace.
See Figures 3.8-3.12 for framing and clearance
details.
Figure 6.6 Nailing Tabs
Shipping Position
Figure 6.7 Nailing Tabs
Installation Position
SHIPPING
FLANGE
NAILING
TAB
SHIPPING
FLANGE
NAILING
TAB
1 IN. STANDOFF
Securing and Leveling the Appliance