Use and Care Manual

Maincraft
Page 6
CB)
Connect the water supply pipe to the faucet, and
carefully bend the pipe to make it match the water
supply shut-off valve. Ensure the pipe is sealed.
(Always wash the sediments in the water supply pipe
away before connecting the
angle Stops
Cutting machine
Use the cutting machine or electric drill to
make holes along the auxiliary line, and sand
the edge of the holes.
Use the cutting machine or electric drill to make Install the faucet and its components, holes along
the auxiliary line, and sand the edge of holes. Place the cardboard mold to the bottom of the
counter, use a pencil to draw the auxiliary line. Apply special glue water on the contact area of the
basin and counter, and then paste the basin along the auxiliary line with tighgtness (let it dry for
24 hours).
HELPFUL TOOLS
B INSTALLATION PROCEDURES
Make the cardboard mold according to the
pasting surface of the basin.
Place the cardboard mold on the counter, and determine the
installation positions for the faucet and basin according to the
installation requirements for the supporting faucet. Use a pencil to
draw the auxiliary line.
Install a lever faucet on the basin. Install the
faucet and its components.
Tape Measure
Pencil
Impact Drill Adjustable Wrench Screwdriver
Supply Shut-Off Valve
Neutral Mildew Resistant
Silicone Sealant
Teflon Tape
(retracted for 5mm for the inside
circum of each product)
Outside circum of the cardboard
Inside circum of the product
Outside circum of the product
Pasting surface
"Remark
：
'
This installation
instruction may be
suitable for any of
Maincraft
undermount basin.
<
________________________________________
丿
INSTALLATION INSTRUCTIONS
Under mount basin