Use and Care Manual

STEPS FOR ASSEMBLY
P.8 P.8
STEP 5
Hardware:
B
3x15mm
x6
STEP 6
Hardware:
x8
15
9
10
4
4
9
10
4
4
20
15
X4
13
15
X4
STEP 7
Hardware:
x4
A
6X40mm
9
10
13
Back of panel
(13)has 2 holes
for next step.
N
12
10
13
10
12
STEP 8
Hardware:
x4
K
5x40 mm
Attach the bolts (A) to the drawers’ box bottom panel (13),
then assemble the Left and Right panels (9) and (10) as shown.
x2
L
6x25 mm
IMPORTANT: Make sure you use in this step the correct sliders ( 4 ) which are longer and have more holes than sliders ( 22 ).
Use screws ( B ) to assemble the scanner sliders ( 4 ) to the top sets of slider holes on panels ( 9 ) and ( 10 ) in the following order:
First open the slider slowly until the first hole on the front of the slider is visible through the big opening, and attach to the front hole on the
panels as shown. The open the slider completely and attach to the 2 back holes as shown.
Secure the back panel (12) to the side panels
(9) and (10) using screws (K) as shown.
Attach the bolts (L) to the drawers box bottom panel
(13), and assemble the back panel (12) as shown.
Then attach the grommet (N) to the back panel (12).