Use and Care Manual

P.5 P.5
BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS.
❶ Do a quick inventory to make
sure the package contains all the
parts and hardware listed
in the
assembly instructions.
❷ Missing, damaged and
defective parts can be replaced
at no cost to you. Please refer
to the CONTACT
card included
with the product.
❸ The replacement parts service
is limited to the continental United
States. If you reside in Hawaii,
Puerto Rico, U.S. Dependencies or
other countries, please contact the
supplier from where the unit was
purchased.
❹ If during assembly you find
an issue or need clarification,
please contact our Customer
Service for assistance. Please
refer to the CONTACT card
included with the product.
❺ On each step read the
instructions and a
nalyze the
illustrations thoroughly
before proceeding to do the
assembly.
❽ Do not overtighten or
force the screws as they
might break, strip
, damage
the threads of the holes or
get stuck inside the part.
❻ Make sure you understand
which hardware will be used on
each step. Using
the wrong size
of screw, bolt or pin might strip
the threads or cause damage to
the part in which it is being used.
❼ To avoid misalignments,
always leave the screws loose
and tighten them until all pieces
are positioned correctly.
❾ Sometimes the laminate might cover partially or entirely the
hole on a panel. I
f there is no visible hole for the screw, pass
and press the tip of your finger over the area where the hole
should be located to feel the indentation, and once found,
carefully pierce the laminate to reveal the hole underneath.
❿ If the hole seems too small for the screw, first make sure
you are using the correct size of screw and that it’s been
installed in the co
rrect hole. If the hole still appears to be too
small, carefully pierce the laminate to reveal the hole’s actual
size.