Hardware reference guide

I/O Modules
35013379 11/2011 643
The output point will be turned OFF after a short is detected. A fault greater than 9.4
A will guarantee that the point will be turned OFF and will latch the output point in
the OFF state. To clear a fault, the point must be commanded OFF in user logic.
Fuse Locations
The following figure shows the fuse locations for the DDO88500 module.
NOTE: At a minimum, Modsoft V2.40, ProWorX NxT V2.0, or Concept V2.0, is
required to configure this module.
CAUTION
Possible danger to equipment or personnel.
Turn off power to the module and remove the field wiring terminal strip to gain
access to fuses.
Failure to follow these instructions can result in injury or equipment damage.