Hardware reference guide

I/O Modules
35013379 11/2011 613
140DDO15310 I/O DC Output 5 V 4x8 Sink Module
Overview
The DC Output 5 V 4x8 Sink module switches 5 Vdc loads.It is for use with shared
output common wired to positive potential and is compatible with TTL, -LS, -S, and
CMOS logic.
Specifications
The following table shows the specifications for the 5 V OUT module.
Specifications
Number of Output Points 32 in four 8 point groups
LEDs Active
F
1 ... 32 (Green) - Indicates point status
Required Addressing 2 words out
Output Ratings
ON Level 0.2 Vdc (max) @ 75 mA sinking
OFF Level V
OUT
= U
S
- 1.25 V @ 1 mA source
V
OUT
= 3.2 V (min) @ 1 mA, U
S
= 4.5 V
Internal Pullup Resistor 440 Ω
Maximum Load Current
Each Point 75 mA (sinking)
Each Group 600 mA
Per Module 2.4 A
Surge Current Maximum
Each Point 750 mA @ 500 μs duration (no more than 6 per minute)
Response (Resistive Loads)
OFF - ON 250 μs (max)
ON - OFF 250 μs (max)
Output Protection (internal) Transient voltage suppression
Isolation
Group to Group 500 Vac rms for 1 minute
Output to Bus 1780 Vac rms for 1 minute
Fault Detection Blown fuse detect, loss of field power
Bus Current Required 350 mA