Hardware reference guide

I/O Modules
35013379 11/2011 519
The following figure shows the wiring diagram for the 140AVO02000 module.
WARNING
Malfunction of equipment
Master override must be connected to an external source through 1/16 A in line
fuse, or strapped to common to avoid erroneous outputs in this module.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
2
10
4
6
8
12
14
16
18
20
22
24
26
28
30
32
34
36
38
40 39
37
35
33
31
29
27
25
23
21
19
17
15
13
11
9
7
5
3
1
R 1
CONTROL 1
Jumper
Jumper
R 2
Jumper
Jumper
Jumper
Jumper
OUTPUT 1 (+)
N/C
N/C
N/C
R 3
R 4
OUTPUT 2 (+)
OUTPUT 3 (+)
MASTER OVERRIDE
COMMON 1 (-)
COMMON 1 (-)
COMMON 1 (-)
See
NOTE 1
COMMON 2 (-)
See
NOTE 1
See
NOTE 1
COMMON 2 (-)
COMMON 2 (-)
COMMON 3 (-)
COMMON 3 (-)
N/C
MASTER OVERRIDE
COMMON 3 (-)
See
NOTE 1
COMMON 4 (-)
COMMON 4 (-)
1/16A
+
+
-
-
EXTERNAL
VOLTAGE
SOURCE
The external voltage source
is not required for standard
operation (NOTE 1 : see External Wiring Recommendation).
CHANNEL 4
JUMPERED
FOR 0 TO 10 V
CHANNEL 3
JUMPERED
FOR + / - 5 V
Normally
Closed
Normally
Open
Typical one
of four
Normally Open when
CH X green LED is ON
Channel
Output X
Master
Override X
Master Override Relay Circuit (Internal)
CHANNEL 2
JUMPERED
FOR 0 TO 5 V
CHANNEL 1
JUMPERED
FOR + / - 10 V
COMMON 4 (-)
MASTER OVERRIDE
MASTER OVERRIDE
N/C
N/C
N/C
N/C
REFERENCE 2
REFERENCE 1 N/C = Not Connected
REFERENCE 3
OUTPUT 4 (+)
REFERENCE 4
CONTROL 2
CONTROL 3
CONTROL 4
FIELD
DEVICE
FIELD
DEVICE