Hardware reference guide

Networking
35013379 11/2011 239
Coax Termination Internal 75Ω
Coax Shield Tied to chassis ground
Data Transfer Rate 1.544 mb
Dynamic Range 35 dB
External Connections
One Channel
(CRP93100)
One "F" type female connector with a right angle adapter
Two Channels
(CRP93200)
Two "F" type female connectors with a right angle adapter
General
Diagnostics Power Up Power Up and Runtime
Dual Port Memory Check Executive Checksum
LAN Controller Check RAM Address/Data
Maximum Number of
CRPs Supported by
the Controller
1
Bus Current Required
(Typical)
Single Channel: 600 mA
Dual Channel: 750 mA
Power Dissipation
(Typical)
Single Channel: 3 W
Dual Channel: 3.8 W
CAUTION
Connectivity Compliance
To maintain CE compliance with the European Directive on EMC (89/336/EEC),
the RIO head module must be connected using quad shielded cable (see the
Remote I/O Cable System Planning and Installation Guide, 890USE10000, V2.0).
Failure to follow these instructions can result in injury or equipment damage.
Specifications