Hardware reference guide

210 35013379 11/2011
5 Mode (Push Button): Press and hold this button to change from slave mode to bus mode.
6 Address (Push Button): Press this button to scroll through the 32 slaves. Hold to reverse
direction of the scroll.
7 AS-i Channel Cable Connector: Connects module to AS-i cable and AS-i power supply.
LED Display and Descriptions
Diagram of the LED display:
The following table provides LED descriptions.
LED Bus Mode
Each indicator lamp 1-31 corresponds to a slave address on the bus.
z On: Slave is present.
z Flashing: Slave is mapped but not detected, or detected but not mapped. It may
also be projected and detected, but not activated (bad profile or I/O code).
z Off: Slave is neither mapped nor detected.
LED Descriptions
LED Color Description
Active Green Bus communication is present.
F Red Fault on the AS-i bus.
Steady: module fault
Flashing: bad bus configuration or slave address
B Green Communication exists between master and slaves.
0-31 Green Slave indicators.