Installation Guide

Carefully place the box on the wall at about 130 cm to 165

cm above the floor, or according to your preference. Make

sure the box is completely level, then mark the center of all

four mounting holes.

Use a Phillips Head screwdriver to remove

the handle from the inside of the bin door

then re-attach the handle to the outside of

the bin door.

130 cm to 165 cm

LEVEL

6.5”

(165.1 mm)

9.6”

(230.19 mm)

Using the 4 mm drill bit provided, create four pilot holes

around 40 mm deep (about 10 mm deeper than screws

provided). If the material is unusually hard you may need to

use a rotary impact drill rather than a standard drill to make

the holes. Call a handy man if needed. You may wish to put

a small amount of caulk or silicone into each hole.

Insert the rubber grommets into each of the four

mounting holes by twisting and pushing the grommet

into the hole until it is centered and fully seated.

Then place one steel washer onto each of the four

screws provided. Attach the TORX (T25) bit to a

screw driver or an electric drill (set to low) and

carefully tighten the screws all the way into the wall.

Do not over-tighten the screws or you may break the screws or strip out the holes.

40 mm

Have a question?... Need a part ASAP?...1-800-589-7990

2/6

20-Dec-2019