Specifications

INSTALLATION
Page 36 MRC-565 Packet Data Radio Operations and Maintenance
CHANNEL (cr)
This will show you the “Active” TX and RX Frequency pair and frequency pairs for up to 20
channels that were programmed at the factory.
The following table will be displayed for the SNOTEL network:
+CHANNEL 01/01/00 01:08:29
Primary Channel TX mhz RX mhz Mod-Val Bit rate Modulation
07 41.6100 40.6700 3 9.6K gmsk9.6
Channel Table:
Channel TX mhz RX mhz Mod-Val Bit rate Modulation
00 40.0000 40.0000 3 9.6K gmsk9.6
01 46.000 46.0000 3 9.6k gmsk9.6
You can select any frequency pair from the frequency table by entering the following commands:
ASSIGN,RX1,n Where n is the channel number you want to assign to RX1.
CHANNEL, n Where n is the desired channel number
For example: To select channel 0 above enter:
ASSIGN,RX1,0
CHANNEL, 0
The active channel is the one with > in front and * after the channel number, 07 in this case.
The table above shows all the assigned channels and is Locked into each MRC radio before it
leaves the factory. Operation on channels beyond those listed is not possible without sending it
back to the factory for reprogramming.
4.3.5 Select Site Name
A descriptive name may be given to the site where the MRC-565 is being installed. The selected
site name must be coordinated with your System Administrator. To enter a site name use the
following command:
SITE NAME, XXXXXX [ENTER]
where XXXXXX may have a maximum of 32 alpha-characters.