Specifications

APPENDIX A: COMMANDS
Page 156 MRC-565 Packet Data Radio Operations & Maintenance
MRC-565 COMMANDS
TABLE
COMMAND
DESCRIPTION
PARAMETERS
RANGE
the radio. The radio will not transmit the position
information if there is no GPS connected, you can
use “UPDT, POS” to transmit your location
information.
Example: 47:14.1234N,122:16.7812W,12.89
LOCK,{ID,CHANNEL,CONF
IG}
Lock the ID, Channel, Config settings. Valid radio
ID must be entered to lock the ID structure.
Valid frequency CHANNEL must be entered to lock
the Channel structure.
Valid Serial Number, Customer ID, DSP image must
be entered to lock the Channel structure.
LOGOFF
Used to disallow operator commands with automatic
10 minute timeout for LOS role and 60 minute
timeout for TRANSPOND role. Logs you off,
disables ALL following operator commands except
LOGON, $PENTM, or SDATA.
LOGON,password
LOGON used to allow operator commands. To log
onto a unit, enter the LOGON command followed by
the current password. This will remain in effect for a
timeout period (10 or 60 minutes depending on
operating mode), or until you log off. Default =
MCC-6100
Password = 3-20
character password
A-Z, 0-9, -
*LOS CHECKIN{,ii,rr}
Select check-in interval (in seconds) and retry count
for LOS operation.
ii = interval
rr = retry
1 – 65535
1 – 65535
LPM{,OFF}
LPM,SP
Turns LPM OFF
LPM,SP
Receiver Front End fully operational. Main
Processor and DSP go to lowest power state,
Ethernet turned off. DSP and CF wake up
when FPGA detects a signal above FPGAHI
LPM,OFF
LPM,SP1