Manual

Page 8
New
Waste
3
New
1
Engine
Block
PINCH
HOSE
Radiator
Clear Hose
Plug Adapter
Overflow
Cone
Hose
Pump
Water
2
New
WARNING
Do not overfill the
Waste Tank
Empty Radiator continued
6. Connect the Adapter Hose to the radiator overflow port to relieve radiator pressure. Watch the
System Vacuum Gauge and make sure the vacuum level increases and then stays greater
than 20 InHg. Carefully remove radiator cap. Use a shop rag over the cap when removing
to avoid injury in case there is still pressure. Remove the Adapter Hose.
7. Place VCX Cone Adapter snugly into the radiator spout. Do not force the Cone Adapter into
the spout, the suction pressure from the VCX should secure it adequately. Verify that the
Cone Adapter Valve is in the open position.
8. Start the engine once fluid
starts to move through the
clear hose and into the VCX
Waste Coolant Tank. Verify
that the System Vacuum
gauge reads at least 22
InHg.
9. Once the waste coolant from
the vehicle stops flowing
through the clear hose, turn
all of the panel valves to
Home Position and turn the
engine off.
DO NOT REMOVE CONE
ADAPTER FROM THE
RADIATOR!
Note: In some cases it may be necessary to pinch off the hose going from the radiator
neck to the overflow container. This is only necessary when the vacuum leaks
through this hose. The hose should be opened only after the Fill Radiator procedure.