Manual

Page 7
Empty Radiator (Continued)
6. Carefully remove radiator cap. Use a shop rag over the cap when removing to avoid injury
in case there is still pressure.
7. Place VCX Cone Adapter snugly into the radiator spout. Do not force the Cone Adapter
into the spout, the suction pressure from the VCX should secure it adequately. Verify that
the Cone Adapter Valve is in the open position.
8. Start the engine once fluid starts to move through the clear hose and into the VCX Waste
Coolant Tank. Verify that the System Vacuum gauge reads at least 22 InHg.
9. Once the waste coolant from the vehicle stops flowing through the clear hose, turn all of
the panel valves to Home Position and turn the engine off.
DO NOT REMOVE CONE ADAPTER FROM THE RADIATOR!
Note: In some cases it may be necessary to pinch off the hose going from the radiator
neck to the overflow container. This is only necessary when the vacuum leaks
through this hose. The hose should be opened only after the Fill Radiator
procedure.
WARNING
Do not overfill the Waste Tank.
New Coolant
Tank
Tank
Adapter Valve
Overflow
HOSE
PINCH
Clear Hose
Hose
Radiator
Cone
Engine
Block
Water
Pump
Waste Coolant