Manual

Page 7
New Coolant
Tank
Tank
Overflow
Valve
Cone Adapter
Hose Adapter
Clear Hose
Radiator
Engine
Water
Pump
Block
Heater
Core
Waste Coolant
New Coolant
Tank
Tank
Adapter Valve
Overflow
HOSE
PINCH
Clear Hose
Hose
Radiator
Cone
Engine
Block
Water
Pump
W
as
t
e
C
oo
l
an
t
Empty Radiator (Continued)
6. Carefully remove radiator cap. Use a
shop rag over the cap when removing
to avoid injury in case there is still
pressure.
7. Place VCX Cone Adapter snugly into
the radiator spout. Do not force the
Cone Adapter into the spout, the
suction pressure from the VCX should
secure it adequately. Verify that the
Cone Adapter Valve is in the open
position.
8. Start the engine once fluid starts to
move through the clear hose and into
the VCX Waste Coolant Tank. Verify
that the System Vacuum gauge reads
at least 22 InHg.
9. Once the waste coolant from the
vehicle stops flowing through the
clear hose, turn all of the panel valves
to Home Position and turn the
engine off.
DO NOT REMOVE CONE ADAPTER
FROM THE RADIATOR!
Note: In some cases it may be necessary to pinch off the hose going from the radiator
neck to the overflow container. This is only necessary when the vacuum leaks
through this hose. The hose should be opened only after the Fill Radiator procedure.
WARNING
Do not overfill the Waste Tank.