Owner manual

ManualsBrandsMAHLE RTI ManualsAccessories for airDCS-1

SAFETY INSTRUCTIONS

• Wear safety glasses or goggles

• Have fire extinguisher available

• Do not smoke or use near ignition source

• Use in well ventilated area

• Clean up any spills immediately

• Keep service hose away from hot or moving

engine parts

• Read the MSDS for any fluids used

BATTERY

The DCS-1 requires two AA batteries. An

access panel is located on the rear and is

secured with two screws. Always insert

batteries with polarity as shown in battery

compartment.

OPERATION INSTRUCTIONS

1 Verify that the batteries are good. With Timer at zero, turn the Power Switch

on. The buzzer should be heard - if not, change the batteries.

2 Start the engine and bring to full operating temperature. Then

turn engine off.

3 Make sure the valve on the bottom of the DCS-1 is closed as

shown to the right.

4 Remove Fill Cap and fill Tank with desired amount of cleaning fluid.

5 Replace Fill Cap - being careful that O-ring is in place.

6 Hang the DCS-1 at a location higher than the engine fuel filter. Position so

both control panels are accessible.

7 Connect hoses as shown in the illustrations using appropriate adapters and

adapter hoses.

! Red hose from engine supply line to port with red marking on bottom

of the DCS-1.

! Black hose from engine return line to port with black marking on

bottom of the DCS-1.

! Loop Hose between return and supply line of the fuel tank.

8 Open the Air Pressure Release Valve by turning counter-clockwise.

9 Open valve on the bottom of the DCS-1. Wait 30 seconds for cleaner to fill the

hose. Then start the engine. If the engine does not start it will be necessary

to pressurize the tank of the DCS-1 with shop air. If so, proceed with the

following steps:

! Close valve on bottom of DCS-1.

! Close Air Pressure Relief Valve by turning clockwise.

! Turn Air Pressure Regulator off by pulling knob away from cabinet

and turning all the way counter-clockwise.

! Connect shop air to port on the bottom of the DCS-1.

! Pull knob on Air Pressure Regulator away from cabinet and slowly

turn clockwise until Pressure Gauge indicates 10 to 15 PSI.

! Disconnect shop air.

! Open valve on bottom of DCS-1.

Page 1 of 2 RTI Technologies, Inc., 10 Innovation Drive, York, PA 17402 Ph.717-840-0678 035-81337-00

Supply

Return

560-80433-00

Injector

Pump

Fuel

Filter

Supply

Return

Fuel Tank

DCS-1

Diesel Cleaning System

Red

Hose

Black

Hose

Loop

Hose

Summary of content (2 pages)

PAGE 1
560-80433-00 DCS-1 Diesel Cleaning System SAFETY INSTRUCTIONS • Wear safety glasses or goggles • Have fire extinguisher available • Do not smoke or use near ignition source • Use in well ventilated area Red Hose Supply Return Injector Pump • Clean up any spills immediately Black Hose • Keep service hose away from hot or moving engine parts Supply Loop Hose • Read the MSDS for any fluids used Return Fuel Filter BATTERY Fuel Tank The DCS-1 requires two AA batteries.
PAGE 2
10 Start the engine. Immediately open the Air Pressure Release Valve to release any remaining pressure and allow gravity flow to continue. 11 Turn Power Switch on and turn Timer knob clockwise to set time. 12 Run engine at 1200 RPM. 13 The Timer will go to zero and a buzzer will sound, indicating the service is complete. If the level of cleaner in the Tank goes low enough, the buzzer will sound to alert that the process should be stopped soon or the engine will be starved for fuel.