Owner manual

Table of Contents
I Introduction ........................................... 1
II Safety ............................................... 2
III Checking out the Parts .................................. 3
Figure 1 Standard Accessories .......................... 4
Figure 2 Optional Accessories .......................... 5
IV Initial Set-up .......................................... 6
Figure 3a Tip Holder and Cutting Tip Setup ................ 7
Figure 3b Mounting the Tool Holder ...................... 8
Figure 4 Drive Belt Position and Adjustment ................ 9
V Cutting Brake Rotors .................................. 10
Figure 5 Mounting a Hubless or Composite Rotor with
less than 6.95" inside hat diameter .............. 12
Figure 6 Mounting a Hubless or Composite Rotor with
Larger than 6.95" inside hat diameter ............ 13
Figure 7 Mounting a Rotor with hub ..................... 14
VI Cutting Drums........................................ 15
VII Locking the Tool Slide ................................. 15
Figure 8 Mounting Hubless Drums ...................... 16
Figure 9 Mounting Drums with Hubs ..................... 17
Figure 10 Setup of Drum Cutting Tool ................... 18
Figure 11 Tool Slide Lock............................. 19
VIII Changing Spindle Speed ............................... 20
IX Adjusting Chain....................................... 20
X Changing Cutting Tips ................................. 20
XI General Maintenance .................................. 20
XII Technical Support ..................................... 20