User Manual

Table of Contents
I Introduction ........................................... 1
II Safety ............................................... 2
III Checking out the Parts .................................. 3
IV Initial Set-up .......................................... 6
Figure 1 Exploded View of Lathe ........................ 5
Figure 2 Assembly Drawing of Transport/Setup Lift .......... 6
Figure 3 Tip Holder & Cutting Tip Setup for Rotors .......... 7
V Cutting Brake Rotors ................................... 8
Figure 4 Centering Plate & Crank Attachment .............. 9
Figure 5 Centering Bell & Long Leg Setups ............... 10
Figure 6 Runout Compensation ........................ 12
VI Alternate Compensation ................................ 14
VII Changing Cutting Tips ................................. 14
VIII General Maintenance .................................. 14
IX Technical Support ..................................... 14