Owner`s manual

88
12
APPEARANCE AND CARE
12.1 Lights...............................
12.2 Turn lights.............................................................
12.3 Interior Light.........................................................
12.4 Brakes...................................................................
12.5 Tyres......................................................................
12.6 Windscreen Washer..............................................
12.7 Wiper blade..........................................................
12.8 Maintenance Schedule..........................................
12.9 Fuse box................................................................
12.10 Interior..................................................................
12.11 Storing of car.........................................................
12.12 Exterior..................................................................
12.13 End of life- disposal...............................................
......................................
89
90
90
90
90
91
91
92
94
96
96
97
97
Appearance and care
89
12.1 LIGHTS
Check operation of your car exterior lights at least
once a week. A burned out bulb creates an unsafe
drive condition by reducing your vehicle’s
visibility and ability to signal indications to other
road users.
Following check list will help:
1. Headlights (low and high beam)
2. Parking lights
3. Turn signals
4. Reverse lights
5. Number Plate light
6. Brake lights
7. All indicator / IP warning lights
8. High mount stop lamp
If you find any bulbs have fused, have them
replaced.
REPLACEMENT OF BULBS
• Headlight:
1.Open bonnet and engage support rod.
2.Disconnect wiring harness
connector from rear of bulb.
3.Pull rubber cap out.
4.Release bulb retaining spring and
remove bulb.
5.Replace bulb with a new one.
6.Install in reverse order of removal.
When installing new bulb, ensure that
lugs on bulb holder engage correctly in
recesses of housing.
7. Install rubber cap correctly in place.
8. Connect connector to rear of bulb.
Greasy hands/fingers will cause stains,
resulting in dull and inefficient light. Do not
touch bulbs with bare hands. Clean with a
non fluffy cloth using spirit.
CAUTION
12.1 LIGHTS
Rear Brake light, High mount stop lamp & IP
cluster lights are part of assembly and for
replacement assembly needs to be replaced.
NOTE
Appearance & care
! Inside of head light lens may get clouded
immediately after washing your car. This
moisture condensation inside head light
lens will disappear gradually as it gets
warmed up by head light. In this event do
switch on headlight for sometime after
car is washed.
! Initial inclination details of head lamp lo-
beam is -1% and load is 55 watts &
corresponding HLLD switch positions.
NOTE