Instruction Manual

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 67
Figure 4-37 - Hopper Transport Belt Tension Adjustment Screw (FRONT RIGHT VIEW)
15) Carefully slip the hopper transport belt off the gear of the motor mounted to the top deck plate, near
the rear of the hopper module (see Figure 4-38).
Figure 4-38 - Hopper Transport Belt and Drive Motor (FRONT RIGHT VIEW)
16) Use both hands to carefully lift the hopper module out of the device, making sure no cables are
snagged on the hopper module or the device, and set it aside.