Instruction Manual

5 - Adjustments
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 166
e) Press the C button to clear the current value.
f) If the letters were too far to the rear of the EC2000, enter a larger number for
BotCardTridgeHomeToIndent. You probably only need to change by 1-5 steps.
g) If the letters were too far to the front of the EC2000, enter a smaller number for
BotCardTridgeHomeToIndent. You probably only need to change by 1-5 steps.
h) Press the E button to finish entering the new value.
i) Press the Save button to save your changes. The system will report “The modified configuration
has been saved.” Press OK to close the popup window.
7) Navigate to Menu > Settings > Service > MCP Cmds to open the Controller Commands page.
8) Under the “Indenter Move” button, select Bot Cartridge Load in the dropdown list.
9) Press the Indenter Move button. The device will move the indenter to the load position.