Instruction Manual

5 - Adjustments
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 163
Look at the FIRST number of Font ID1 (PAN)
Adjust Font ID1 X Offset, Font ID1 Y Offset
Repeat for Font ID2, Font ID3, Font ID4
↑ Font ID1 X Offset
↑ Font ID1 Y Offset
↑ Font ID1Y Offset
↓ Font ID1 X Offset
↑ Font ID1 Y Offset
↑ Font ID1 X Offset
Finished
↓ Font ID1 X Offset
↑ Font ID1 X Offset
↓ Font ID1 Y Offset
↓ Font ID1 Y Offset
↓ Font ID1 X Offset
↓ Font ID1 Y Offset
13) Calibrate the Font ID1 X SPI and Font ID1 Y SPI (steps per inch) settings:
a) Press the Print button. The EC2000 will create a test card with all font IDs.
b) Look only at the last character of the PAN (Font ID1) from all angles, and determine whether
the embossed character is to the left, right, above, or below the printed character.
c) Press the Advanced… button to open the Tuning (Advanced) page.
d) If the embossed character appears to the left of the printed character, increase the Font ID1 steps
per inch adjustment and press the Save button.
e) If embossed character appears to the right of the printed character, decrease the Font ID1 steps
per inch adjustment and press the Save button.
f) Press the Back button to return to the Tuning (Move Embossing) page.
g) Repeat the process until the embossed and printed last character of Font ID1 is aligned.