Instruction Manual

5 - Adjustments
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 153
ii) Press the C button to clear it the value above the keypad to “0.”
iii) Enter 160 on the keypad, then press the E button to change the setting.
iv) Repeat these steps for the next setting until you finish with FontID4, CamAngleBottom.
e) Repeat the steps above to set FontID3 CamAngleTop and FontID3 CamAngleBottom to 110.
f) Press the Save button to save all changes.
4) Press the OK button to dismiss the popup confirming the values have been saved.
5.4.5 How to Set Minimum Thickness Using CamAngle
The embosser must produce a minimum thickness before it makes sense to use knuckle adjustments to
change thickness and bending of a card. To make sure the embosser is reaching that minimum character
thickness, follow these steps:
1) Create and measure a tuning card.