User Manual

8 - Configuration
ExpressCard 2000| Instant Issuance Card Personalization System | User Installation and Operation Manual
Page 65
8.2.2 How to Manually Re-Authorize the Device
To re-authorize the device and test the Internet connection used for re-authorization, follow these steps:
1) Make sure the device has been authorized once in the past with assistance from MagTek Support
Services. The device can not be manually re-authorized until a user has put it through that process.
2) If the EC2000 is not already displaying the Status page, press the Status button.
3) Press the Menu button to display the Main Menu page.
4) Press the Settings to open the Settings Menu page.
5) Press the Authorize/Deauthorize button to open the Device Authorize/Deauthorize page.
6) If you want to test the connection to MagTek’s CA, press the Test Authorize/Deauthorize
Connection button. When a successful connection has been established, the EC2000 will display a
message on the Device Authorize/Deauthorize page stating “The authorize/deauthorize connection
is successfully tested.”
7) If you want to manually re-authorize the EC2000, press the Request To Authorize Device button.
When the re-authorization process has completed, the EC2000 will display a message on the Device
Authorize/Deauthorize page stating “The device is successfully authorized.”
8.3 Client Certificate Option
The EC2000 can be configured for point-to-point authentication by refusing transactions from any card
issuance workstation that does not have a certificate installed.
To configure the client certificate options, follow these steps:
1) From the EC2000 touchscreen, navigate to Menu > Settings > Authorization to open the Device
Authorize / Deauthorize page.
2) Under the Client Certificate Options label, press the … button.
3) Press the OK button to acknowledge that setup passwords are required, and to open the Client
Certificate Options first password page.
4) Enter the first service password and press the E button.
5) Enter the second service password and press the E button. The touchscreen will return to the
Authorize / Deauthorize page with a new Client Certificate Options box at the bottom.
6) Select the option you wish to use, then press the Apply button:
a) The Ignore option directs the EC2000 to accept transactions from senders that present or do not
present certificates for the https transaction.
b) The Require option directs the EC2000 to reject transactions from senders that do not present a
client certificate. For senders that present a valid client certificate, the device will negotiate an
SSL connection with the sender, which will provide authentication, message integrity validation,
and message encryption.
8.4 Passwords
8.4.1 About Passwords
When the EC2000 is shipped, all passwords are set to factory defaults, which can be used to change all
passwords to customer-selected values (see section 6.6 About Passwords and Asterisks for more
information). To obtain default passwords to perform setup, call MagTek Support Services.