Specifications
Table Of Contents
- Table of Contents
- 1 Introduction
- 1.1 About DynaPro
- 1.2 Protection for All Points Within the Payment Infrastructure
- 1.3 Securing Personal Cardholder Data
- 1.4 Security and Ease of Integration by Design
- 1.5 Remote Services
- 1.6 Physical and Electronic Security
- 1.7 Liquid Crystal Display
- 1.8 10-Digit Numeric Pad
- 1.9 Function Buttons (Soft Keys)
- 1.10 Low-Power Standby Mode
- 1.11 Magnetic Card Reading
- 1.12 Chip Card Reading
- 1.13 Contactless Card Reading
- 1.14 About Major Components
- 1.15 About Terminology
- 2 Handling and Storage
- 3 Installation
- 4 Configuration
- 5 Operation
- 6 Maintenance
- 7 Developing Custom Software
3 - Installation
DynaPro| Secure Cryptographic Device for PIN and Data Entry | Installation and Operation Manual
Page 22 of 40 (D99875586-41)
3.5 How to Install and Remove the Privacy Shield
To install the privacy shield, follow these steps:
1) Place the clips of the open end of the Privacy Shield into the openings located just above the contact
card slot, as shown in Figure 3-3.
2) Pivot the shield down, locking the three clips into the holes located just above the function buttons.
Figure 3-3 - Installing the Privacy Shield
To remove the privacy shield, follow these steps:
1) Slowly lift the edge of the privacy shield closest to DynaPro’s display.
2) Pivot the shield up to a 45 degree angle.
3) Remove the shield.