Programmer's99875629 Owner's manual

Appendix J - BLE Module Control Data
DynaPro Mini| PIN Encryption Device | Programmer’s Reference (Commands)
Page 105
Appendix J BLE Module Control Data
This section defines control messages that can be sent to the device’s BLE module. The general format
for control messages is as follows, and the specific commands can be found in subsequent sections:
Byte 0 Message type
0 = Request
1 = Response
2 = Notification
Request message type
Byte 1 Command identifier
Byte 2-n Command request data
Response message type
Byte 1 Response Code
0 (success)
1 (failure)
2 (bad parameters)
Byte 2-n Command response data
Notification message type
Byte 1 Notification identifier
Byte 2-n Notification data
J.1 BLE Module Configuration Properties
J.1.1 Get property command
Request message
Byte 0 0 (Request message type)
Byte 1 0 (Get property command identifier)
Byte 2 Property identifier
Response message
Byte 0 1 (Response message type)
Byte 1 Response code
Byte 2-n Property value
J.1.2 Set property command
Request message
Byte 0 0 (Request message type)
Byte 1 1 (Set property command identifier)
Byte 2 Property identifier
Byte 3-n Property value
Response message
Byte 0 1 (Response message type)
Byte 1 Response code
J.1.3 Software ID property
Property ID: 0x00
Get Property: Yes