user manual

133. Install the crimp/shrink connectors by
stripping a 1/4” of insulation off each end of the
wires. Insert one end of the wire into the crimp
shrink connector and crimp it securely. Using a
heat gun or blow-dryer set on high, shrink the
plastic covering of the connector until the plastic
covering completely around the wire. Crimping
the connector alone is not enough to ensure
a permanent connection; you must shrink the
plastic covering!
134. Here is the extended ETC harness, cover it
with the split loom supplied.
135. Install the ETC connector onto the throttle
body.
136. Locate the Throttle Position Sensor (TPS)
connector on the harness and peel back the tape
and split loom.
05/06
Page 36
2004-2006 Ford F-150 3V Supercharger Installation Instructions magnacharger.com