user manual

66. Remove the eight standard fuel injectors from
the fuel rail by carefully prying the retaining clips
off the rail with a small screwdriver. With the clips
removed, pull the injectors off of the rail.
67. Using some of the grease supplied,
lubricate the injector O-rings and install the
supplied injectors . The clips will not be re-used.
65. Carefully remove the intake manifold gasket
from each side of the manifold.
68. Using some of the grease supplied,
lubricate the lower injector O-rings. Carefully
install the fuel rail assembly with the injectors onto
the supercharger manifold. Take care to align
each injector with its hole in the manifold.
The following steps are important!
1. Rotate the injectors so that the injector elec-
trical connector is at a right angle to the fuel rail,
pointing straight out to the sides of the vehicle.
2. Use the original fuel rail bolts and tighten them
to 89 in-lbs (10Nm) using a torque wrench and
8mm socket.
90 Degree
to Fuel Rail
05/06
Page 19
2004-2006 Ford F-150 3V Supercharger Installation Instructions magnacharger.com