user manual

Remove This Bolt
192. On the upper right front face of the air
conditioner condenser, locate the small
bolt shown and remove it using a 8mm
socket wrench.
193. Position the heat exchanger mounting
bracket over the bolt hole and pass the
original bolt through the bracket and
into the original hole. Tighten the bolt
securely using a 8mm socket wrench.
Screw Location
194. Note that the heat exchanger mounting
bracket aligns over a small bolt hole in
the air conditioner condenser.
195. Align the bracket with the hole in the air
conditioner condenser and install the
self-tapping screw supplied into the hole.
Tighten the self-tapping screw using a
8mm wrench and then tighten the lower
mounting bolts securely at this time
using a 10mm socket wrench.
Self-Tapping Screw
9/07
Page 51
2005-2007 Ford Mustang Supercharger Installation Instructions
magnacharger.com